+1(503) 655-5059
Home > Videos > SmartDesign
Using SmartDesign™ in EasyPower

This webinar is taught by David Castor, an EasyPower engineer. He will give an introduction to using SmartDesign, an EasyPower module which allows you to auto-size equipment such as feeders, breakers, switchgear, fuses, etc. He will discuss sizing based on load versus bus rating, the impact of equipment type selection, and creating a custom design sheet. He will also go into voltage crop verification, as well as options you can set within SmartDesign.

 
V509
Download free demo

 Watch our most popular videos

EasyPower OnSite Intro

Utility Short Circuit & Arc Flash

Arc Flash Hazard Reduction

Arc Flash Hazard Reduction

Dynamic Stability Studies


 See all of our training videos